Daren Sefcik

  • Home
  • Featured
  • Galleries
  • Panoramas
  • Virtual Panorama Tours
  • Blog
  • Contact
  2. Photography
  3. Film

Pentax 6x7 TTL Prism Repair

Repairing a broken contact wire and adjusting the exposure meter
Read More
My first solder attempt was not successful, the wire ended up being too short
17 / 24

My first solder attempt was not successful, the wire ended up being too short

Pentax6x7TTLPrism

  • The +6 volt wire had broken inside and caused the meter to work sporadically
  • Untitled photo
  • My first solder attempt was not successful, the wire ended up being too short
  • My first solder attempt was not successful, the wire ended up being too short
  • My first solder attempt was not successful, the wire ended up being too short
  • I soldered in a new, longer piece and finished it with some shrink tubing
  • I soldered in a new, longer piece and finished it with some shrink tubing
  • The new wire all neatly tucked away
  • You can see the exposure meter needle with the top off which makes it easy to adjust
  • Here I am holding the on/off switch on to test the meter. A small alligator clip also works well
  • All finished and working great
  • Untitled photo
  • No Comments
  • Photo Sharing
  • About SmugMug
  • Browse Photos
  • Prints & Gifts
  • Terms
  • Privacy
  • Contact
  • Owner Log In
© 2021 SmugMug, Inc.